K150 Pic Programmer Software Windows 10 Verified [SAFE]

Complete Guide to K150 PIC Programmer Software on Windows 10

This usually means the software is looking at the wrong COM port, or Windows updated the PL2303 driver in the background. Re-verify your COM port assignment in Device Manager and ensure the older driver is still selected. Error: "Driver Error Code 10" or "Code 43"

The K150 is a low-cost, USB-based In-Circuit Serial Programming (ICSP) tool, commonly sold as a kit or a fully assembled unit. It is primarily designed to program a wide range of 8-bit PIC microcontrollers, including many popular baseline and mid-range devices, through a built-in ZIF (Zero Insertion Force) socket or its 6-pin ICSP header. However, due to its aging hardware and software, it is by its manufacturer. Most listings state compatibility with Windows 98 through Windows 7, making Windows 10 a challenge that requires some ingenuity to overcome.

Now that your K150 is successfully communicating with your Windows 10 PC, you can begin uploading your compiled code to target chips.

Without correct drivers, none of the K150’s software (e.g., PICPGM , IC-PROG , or WinPIC800 ) will communicate with the programmer. k150 pic programmer software windows 10

Before starting the installation, you need to download the legacy driver and the Micropro application.

Solution: Verify you selected the correct chip model in the drop-down list. Also, check that your compiler configuration matches the memory limitations of your specific PIC model.

The K150 uses a generic USB-to-serial bridge chip (often the or a clone). Windows 10, especially versions 1607 and later, dropped support for older PL2303 drivers (pre-2012) due to stability and security issues. Consequently, Windows 10 may either not recognize the K150 or mark it with a "Code 10" or "Code 31" error in Device Manager.

A list of installed driver versions will appear. Uncheck "Show compatible hardware" if necessary, but you should see multiple versions of the Prolific driver. Select or Version 3.3.2.102 [2008] and click Next . Complete Guide to K150 PIC Programmer Software on

Step 2: Fixing the Windows 10 Driver Issue (The Critical Step)

By freezing your Prolific drivers to a legacy version and adjusting administrative access properties, the K150 remains a highly effective, cost-efficient flashing tool for microcontrollers under modern Windows 10 operating systems.

Click > Load and select your compiled .hex compilation file.

Check the box for and select Windows 7 or Windows XP (Service Pack 3) from the drop-down menu. It is primarily designed to program a wide

The primary software used to interface with the K150 hardware is Microbrn.exe Phipps Electronics Functionality

For a hassle-free experience on Windows 10:

What (if any) are you seeing in the Micropro window?