Sc569-00 Ricoh !free! -

Do not skip fuser overhaul at the recommended PM counter (usually 300k–600k prints depending on model). Replace the thermistor, lamp, and pressure roller as a set.

Reassemble the unit, ensuring all springs and retention clips are anchored correctly. 3. Perform a System Service Reset (SP 5-810)

Enter Service Mode (typically by pressing → 107 → hold Stop/Clear for 3+ seconds). Navigate to System SP . Find and execute SP 5810 (SC Reset) . Restart the machine to complete the process.

Navigate to the pressure roller HP sensor check. sc569-00 ricoh

Máy photocopy Ricoh báo lỗi error SC 569 là gì và cách khắc phục

A: If the error returns after replacing both the sensor and motor, focus on the mechanical drive train and connections. Re-check the fusing unit's connector to the machine and look for a failing one-way gear in the fuser drive unit. In some cases, the encoder plate can be misaligned; ensure it is in the correct home position.

Navigate to > Mode 5 > Submenu 5810 (SC Reset) and tap it. Restart the machine completely. Do not skip fuser overhaul at the recommended

Before attempting a software reset, perform a physical inspection of the hardware:

If you are a technician, verify the U-shaped sensor is clean and the lift motor is receiving power.

: Excessive load on the fuser motor, often caused by damaged fuser film, a worn pressure roller, or seized bearings, can prevent the motor from rotating. Find and execute SP 5810 (SC Reset)

If you have cleared a physical jam but the error remains, you may need to reset the system through the Service Program (SP) mode.

The first and simplest solution is to verify the toner bottles.

Some fuser errors require a software reset via Service Mode (SP5-810).

The error on Ricoh devices is a Fusing Pressure Release Motor Error . It occurs when the machine fails to detect the home position of the fusing pressure release mechanism after three consecutive retry attempts. Common Causes