Ericsson Mini Link Cli Commands -

Before touching anything, check the unit's uptime and current status. This tells you if the unit has rebooted recently (indicating a power cycle or crash) and verifies the software version.

SET USER PWD=<OLD_PASSWORD>, NEWPWD=<NEW_PASSWORD>

ping 192.168.1.1

SET IP GATEWAY=<GATEWAY_ADDRESS>

This comprehensive guide covers essential CLI commands for Ericsson MINI-LINK TN, CN, and LH systems. 1. Accessing and Navigating the MINI-LINK CLI

The active alarms show what is broken now , but the log shows what broke yesterday .

To set a port as an access port (untagged) or trunk port (tagged): ericsson mini link cli commands

This is the core functionality of the MINI-LINK. These commands manage the link between the IDU and ODU, and the microwave transmission.

Accurate timing is crucial for many services. The CLI allows detailed control over synchronization sources, such as:

Exports the current configuration file to a remote TFTP server for disaster recovery purposes. Before touching anything, check the unit's uptime and

| Mode | Prompt Example | Purpose | |-------|----------------|---------| | User Exec | > | Basic monitoring, ping, show commands | | Privileged Exec | # | Configuration, reset, software actions (enable via enable command) | | Global Config | (config)# | System-wide settings | | Interface Config | (config-if)# | Radio or Ethernet port parameters |

While a Node GUI is available, its configuration features are often limited compared to the depth offered by the CLI. The CLI has been the primary tool for performing serious configuration work, scripting, and large-scale maintenance for years.

| Command Output Field | Meaning | Typical Good Value | |----------------------|---------|--------------------| | RSL (Rx Signal Level) | Received signal | -40 to -60 dBm | | XPI (Cross Polarization) | Antenna polarization isolation | >25 dB | | MUT (Minimum Unfaded Threshold) | Fade margin | >30 dB | | TX Power | Transmitted power | +15 to +25 dBm | | BER (Bit Error Rate) | Raw before FEC | < 10^-6 | These commands manage the link between the IDU