Move the affected person to fresh air. If symptoms or respiratory irritation persist, consult a physician.
Ensure adequate ventilation, especially in confined spaces. Avoid direct contact with eyes and prolonged contact with skin. Do not eat, drink, or smoke while handling this product. Wash hands thoroughly before breaks and after finishing work.
Nitocote PE135 is a single-component, grey liquid coating used for the chemical and abrasion protection of concrete. Petrolinetech
Disclaimer: This article is intended for educational and general informational purposes based on the chemical profiling of bituminous rubber emulsions like Nitocote PE135. Always consult the latest official manufacturer-issued Material Safety Data Sheet (MSDS) and Technical Data Sheet (TDS) provided by Fosroc/Fosam for specific, batch-controlled safety parameters and compliance guidelines before executing on-site chemical applications. nitocote pe135 msds
Remove contaminated clothing and wash the skin immediately with soap and water. Do not use solvents to clean the skin. Eye Contact:
Remove contaminated clothing. Wash the affected skin thoroughly with soap and water. Do not use solvent thinners to clean skin.
To ensure you have the most accurate, complete, and legally compliant safety information, you must obtain the official SDS directly from the manufacturer. Follow these steps: Move the affected person to fresh air
Treat cured or uncured waste material in accordance with local, state, and national environmental regulations. Do not allow the liquid product to enter watercourses.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Nitocote PE135 represents a safe, efficient, and technologically advanced alternative to traditional solvent-laden bituminous coatings. By reviewing and understanding the , project managers, safety officers, and applicators can guarantee a hazard-free work environment while achieving superior waterproofing and concrete protection. Always obtain the most up-to-date safety data sheet directly from Fosroc or your authorized distributor prior to commencing work on-site. Avoid direct contact with eyes and prolonged contact
In the event of a spill, the response should include the use of personal protective equipment (PPE), containment of the spill with inert absorbent materials (like sand or earth), and proper disposal in accordance with local regulations. Never allow the product to enter drains or waterways.
: Surface drying is rapid, taking approximately 35–40 minutes at 20°C and as little as 4–6 minutes at 45°C. Resistance
: Waterproofing and chemical-resistant protective coating for concrete substrates. www.aquaproofpune.com Section 2: Hazard Identification Classification