Rename the dump file exactly to gx6605s_all.bin or rom.bin (depending on the specific mainboard revision).
Double-check that the file name specifically says "SR-5090HD Extreme". Step-by-Step Update Procedure (Via USB)
Copy only the .bin file to the root of the USB drive (do not put it inside a folder). 2. Update via Menu Insert the USB drive into the StarSat SR-5090HD Extreme. Press on your remote. Navigate to Tools (or Expansion). Select Upgrade via USB . Select the Update File (the .bin file you downloaded). Select Start and press OK.
Updating with a dump file is more involved than a standard USB update. It often requires a computer, a special loader tool, and a specific type of cable. dump starsat sr5090 hd extreme upd
: 2x USB 2.0 Ports, HDMI, and Wi-Fi network support via a USB antenna
This process carries the risk of "bricking" your device if done incorrectly. Before attempting any update, verify that your archive utility (like WinRAR or 7-Zip) is the latest version to avoid false "corrupted file" errors.
You are likely attempting to install software for a different model (e.g., trying to put 5090HD Extreme firmware on a 5090HD non-extreme). Rename the dump file exactly to gx6605s_all
If you're looking for help with a specific issue, could you tell me (e.g., black screen, logo, error message) so I can guide you on whether to use a USB update or a flash programmer? Share public link
For optimal performance, StarSat International recommends performing a Factory Default reset immediately after installing any new software updates from their authenticated site.
Looking for the Starsat SR-5090 HD Extreme dump file? Our guide explains how to update and repair your dead receiver, identify mainboard versions, and flash firmware safely. Navigate to Tools (or Expansion)
If the serial port fails to connect, the SPI flash chip must be desoldered and flashed using an external USB programmer tool (such as the CH341A Programmer). This method requires basic soldering skills. ⚠️ Important Precautions
[ PC / Laptop ] ---> (RS232 to 3.5mm Jack Cable) ---> [ SR-5090HD Extreme ]
Do not turn off the power during this process, as it can permanently damage the hardware. 3. Recovery via RS232 (Bricked Device) If the device will not turn on or is stuck on "Boot":
The official Starsat website has been inconsistent over the years. The most reliable sources for updates are the dedicated satellite community forums:
If your receiver’s RS-232 port is damaged or your PC lacks one entirely, you can use the internal UART header: