Hold them for approximately 3 seconds until the indicator light comes on.
Press the corresponding button to switch control seamlessly to the connected RI component. Troubleshooting Tips The remote does not operate your Onkyo receiver
This comprehensive guide serves as your complete manual for the Onkyo RC-799M, detailing supported models, programming instructions, button functions, and troubleshooting steps to get your home theater running smoothly. Supported Onkyo AV Receiver Models
Aim the remote at your component and press SOURCE POWER . If the device turns off, the programming was successful. Common Brand Codes (Reference) Samsung TVs: 12051, 10702, 10060 Sony TVs: 10810, 11685, 10000 LG TVs: 11265, 10178, 11178 Apple TV: 52615 Managing Zone 2 Operations
Point the remote at your device and press to test functionality. Resetting the Remote to Factory Defaults
If you are reading this, you have likely just unearthed a classic piece of AV history—or you are currently sitting on your couch, pressing buttons on a sleek, black wand that refuses to turn up the volume on your receiver.
Note: The [RECEIVER] and [ZONE 2] buttons are pre-programmed for the Onkyo system and cannot be assigned other device codes. Essential Functions and Operations
Input & Source
The RC-799M is a . It controls not only your Onkyo receiver but also up to 4 other devices (TV, cable/satellite box, DVD/Blu-ray, and game console).
If you own an Onkyo home theater receiver from the late 2000s or early 2010s—such as the , TX-SR578 , or HT-RC160 models—you’re likely holding the RC-799M remote control. It’s a sleek, fully-featured universal remote, but finding the original printed manual can be a challenge.
controls Onkyo receivers out of the box, you can program it to operate other devices like TVs or cable boxes using the following steps: How to Configure Onkyo Settings Review
The is more than just a button map—it is the key to unifying your home theater. By understanding how to program device codes, create macros, and perform resets, you transform a simple remote into a powerful control center.
If successful, the Remote Mode button will flash twice.
Dirty IR lens or dying capacitors. Fix: Clean the dark red plastic bulb at the top with a microfiber cloth. Replace batteries even if they read "good" on a voltage meter—IR remotes are sensitive to voltage drop.
If the remote supports discrete codes or device mode switching, try the following:
Proper battery maintenance ensures your programmed codes do not erase prematurely.
Ensure there is a clear line of sight between the remote and the infrared (IR) sensor on the front panel of the receiver.