!!top!!: Makerbase Mks Dlc V21 Manual Link

Plug your 4-wire stepper motors into the corresponding X, Y, and Z ports.

Plug your 4-pin NEMA 17 stepper motors into the corresponding ports. If a motor spins in the wrong direction, you can flip the plug or change the direction in the GRBL settings ($3). 4. Laser or Spindle

Connect your DC power supply to the screw terminals. Double-check the polarity (+ and -) marked on the board. Most setups use 12V for lasers and 24V for CNC motors to get better torque. 2. Stepper Drivers

Makerbase MKS DLC GitHub Repository

Defines how many motor steps are required to move the tool 1 millimeter.

Calibrate these values so a commanded 100mm move results in exactly 100mm of physical travel. Troubleshooting Common Issues

Select the correct COM port, set the baud rate to , select the ATmega328P device, and upload the file. Critical GRBL Settings ( $$ ) makerbase mks dlc v21 manual link

Understanding the hardware limits prevents permanent damage to your board. Here are the core specifications of the MKS DLC V2.1:

Use the serial interface to set GRBL parameters, such as steps per millimeter and max speed.

Here are a few tips and tricks to help you get the most out of your MakerBase MKS DLC V21: Plug your 4-wire stepper motors into the corresponding

The board uses the CH340 serial chip. Ensure the CH340 USB driver is installed on your PC before attempting to connect via USB.

Supports both Normally Open (NO) and Normally Closed (NC) switches via GRBL settings. Laser and Spindle Control