Full ^hot^ | Dp Dual Trac 20 Assembly Instructions

: Insert the vertical weight plate rods into the bottom base piece and secure them with carriage bolts.

: Slide the weight plates onto the rods. Ensure the pin holes face forward and the larger holes face outward.

Your DP Trac 20 parts diagram shows the exact order of plates and spacers – follow it carefully.

: Includes two pull bars, an incline bench, a bench press bar, and a butterfly press attachment.

Connecting the top frame stabilizes the entire machine and locks the vertical posts into place. dp dual trac 20 assembly instructions full

Feed the button-end of the cable over the frontmost overhead pulley. Secure the pulley inside the housing with a bolt, spacer washers, and a nut.

: The incline bench usually attaches via spring-loaded pins for easy removal or adjustment.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

: Go back and tighten every bolt once the entire frame is assembled. Lubrication : Insert the vertical weight plate rods into

Drop in the specific post and place a small top plate on it to cover the T-bars, which prevents the post from being removed accidentally.

Insert the two chrome weight guide rods into the receiving holes on the rear base stabilizer.

: Bolt the two main vertical posts to the base.

Slide the rubber bumper cushions onto the bottom of each guide rod. Your DP Trac 20 parts diagram shows the

Stand the central vertical mast onto the rear section of the center base beam. Secure it using two hex bolts, washers, and nuts through the pre-welded mounting plate.

Assembly Tip: Do not tighten any bolts completely until the entire frame is assembled. Keeping the hardware hand-tight allows the frame to flex, making it much easier to align bolt holes in later steps. 2. Step-by-Step Frame Assembly Step 1: Base and Main Mast

Attach the two rear weight plate guide rods to the base frame.

: Slide the weight carriage onto the guide rods before bolting the top cross-frame.