: Windows 7, 10, or 11 with administrative privileges. Method 1: Automatic Driver Installation via Software
This article is for informational purposes. Always refer to the latest XINJE documentation for model-specific instructions.
To install the USB driver for a Xinje PLC, you typically need to install the specific programming software for your PLC series, which often includes the necessary drivers automatically 1. Download Required Software
Because Xinje USB drivers are often unsigned or require manual mapping, using the Windows Device Manager is the most reliable installation method. xinje plc usb driver install
Click . Windows will scan the folder, locate the driver payload, and complete the installation.
: Administrative privileges on your PC to install hardware drivers. Step 1: Locate the Driver Files
Click or Check Connection . A popup should confirm that the PLC is successfully connected. Troubleshooting Common Installation Issues Windows Blocked the Driver (Digital Signature Error) : Windows 7, 10, or 11 with administrative privileges
Open , right-click the Xinje device, and select Properties . Go to the Power Management tab.
Click on or Communication Settings in the top menu bar.
If the installer fails, install the INF file manually: To install the USB driver for a Xinje
Windows occasionally blocks Xinje drivers because they lack a digital signature verified by Microsoft.
. Windows will install the driver. You may see a security warning; select "Install this driver software anyway" ✅ Step 4: Verify the Connection Once installed, the device should appear under Ports (COM & LPT) as "USB Serial Port (COMx)" or under Universal Serial Bus controllers Communication Settings
Once the driver is recognized as a "USB Serial Port (COMx)," you must link it to your programming environment. Software Identification for XD/XL series PLCs and for XC series models. Port Setup Comm Mode Settings Software Serial Port Config Select the specific number assigned in Device Manager.
Power on your Xinje PLC using the correct power supply voltage. Plug the USB cable into the PLC’s programming port.