While simple in design, this system allows you to preset two different heating levels—one for the initial stretch and another for the final pull—enabling the production of everything from long, thin microinjection needles to firm, blunt microelectrodes for patch-clamping. Key Specifications & Features
Thread the glass capillary vertically through the center of the platinum heating coil.
Labs that need consistent, simple puller for standard patch pipettes (1–5 MΩ) without complex programming. Excellent for teaching labs or routine recordings.
Your (e.g., patch-clamp, microinjection, or extracellular recording)
Store the pulled pipettes in a dust-free, enclosed pipette storage box. 5. Troubleshooting and Maintenance Probable Cause Corrective Action Heater dial set too high or pull weights are too light. narishige pc10 manual new
The original PC-10 manual included a table correlating dial settings (e.g., 45–55 for 1mm borosilicate) to expected tip resistance (in MΩ). Without this table, you are guessing.
Houses the power switch, heater digital indicators/knobs, stage selectors, and pilot lamps. Specifications Pulling Mechanism: Vertical, gravity-driven.
Here’s an interesting, story-driven write-up based on the search query — tailored for a blog, forum post, or product listing.
Unpacking a new Narishige PC-10 requires verifying all standard components to ensure safe installation and accurate calibration. Product Specifications While simple in design, this system allows you
Stage two will immediately activate, firing the electromagnet and applying the secondary heat to separate the glass into two identical micropipettes. 5. Parameter Optimization and Customization
: The heater unit will move to a second position automatically. Second Pull
Press Start. If the glass does not melt within 10 seconds, abort the run.
Your (e.g., patch clamp, microinjection, or microperfusion) Excellent for teaching labs or routine recordings
What is the of your glass capillaries?
– you must visually judge melting. This is the PC-10’s biggest limitation (and simplicity).
If you need help setting up parameters for a specific type of experiment, tell me: