Route all low-voltage DC cables away from the high-voltage AC mains wiring. Use the knockout holes provided on the enclosure. 3. Commissioning the Unit Verify all wiring is correct and free of short circuits. Connect the backup battery leads (Red to +, Black to -). Turn on the 230V AC mains supply at the fused spur.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Elmdene Products
If you are looking for the official Elmdene Product Technical Guide or the specific Rapier G Range Instruction Sheet , they are available on the official Elmdene Downloads page .
Utilize the "Silent Engineer Start-up" feature to test connections without activating the full-volume siren. Troubleshooting and Maintenance elmdene 7422-sfg-g3f manual
The (and associated range, often designated as 7422-SFG-G3F, denoting a stainless steel high-grade unit) is a robust, self-powered external sounder engineered for superior performance in commercial and residential security systems. It meets the rigorous demands of EN50131-4 Security Grade 3 standards. 1. Introduction to the Elmdene Rapier G3S (7422-SFG-G3F)
Connect to the panel's negative bell trigger. The sounder activates when this terminal is pulled to 0V (or +12V is removed, depending on jumper settings).
Draws current only from the panel.
Undo the fastening screws and remove the polished stainless steel cover.
By respecting the engineering and following the guidance laid out in the manual, the Elmdene 7422-SFG-G3F will provide a decade of trouble-free service to your critical security infrastructure.
: Durable metal box with front and rear tamper protection Terminal Block Wiring Connections Route all low-voltage DC cables away from the
“2. The Elmdene 7422-SFG-G3F is not an alarm. It is a key. To find the lock, reverse the polarity of terminals 4 and 7, set dip-switch 3 to ‘ON,’ and place your left hand on the chassis during the second tone.”
Elmdene's official website or the distributor (e.g., ADI, CEF). The manual part number is typically printed on the unit’s inner door.
Connect to the permanent 0V (GND) return from the panel. Commissioning the Unit Verify all wiring is correct
A: No. The IP30 rating means it is not dust-tight or water-resistant. It must be installed inside a secondary weatherproof enclosure or indoors.