Press and hold the or MODE button for roughly 3 seconds until the year or hour digits begin to flash.
: If the clock doesn't set after 12 minutes, move it to a different location away from electronics like TVs or computers, which can cause interference.
This comprehensive manual provides the exact steps required to initialize, manually set, and troubleshoot your Kincaid radio-controlled clock to ensure optimal performance. 1. Quick Start: Initial Setup and Synchronization
Practical items:
Ensure the DST setting in your clock's configuration menu is set to ON or AUTO . The clock will automatically read the DST bit embedded in the WWVB radio signal and advance one hour forward in the spring, or fall back one hour in the autumn. kincaid radio controlled clock instruction manual
Signal Reception Tips
Radio waves are easily blocked by modern construction materials and electronic devices. Try the following signal optimization steps:
Ensure the switch on the back of the clock is set to ON . This allows your Kincaid clock to automatically advance one hour in the spring and fall back one hour in the autumn. If you live in Arizona or parts of Indiana that do not observe DST, switch this to OFF . Step 5: Wait for the Signal Synchronization
You must tell the clock which time zone you live in so it can apply the correct offset to the atomic signal. Locate the time zone button on the back of the clock (often labeled or PT / MT / CT / ET ). P – Pacific Time M – Mountain Time C – Central Time E – Eastern Time Press and hold the or MODE button for
Most Kincaid models feature an automatic DST on/off switch on the back panel.
, preferably one facing toward Fort Collins, Colorado.
Avoid placing the clock in direct sunlight, near heating vents, or close to drafty air conditioners. The internal thermometer requires stable ambient room air to measure temperature accurately. 6. Product Care and Maintenance
You have purchased 20 grams of plastic, copper, and silicon that is, at this very moment, listening to a frequency older than your grandparents. Trust the flash. Trust the spin. When the tower icon goes solid, you are no longer living in your private time. You are living in official time. Signal Reception Tips Radio waves are easily blocked
The display will show a default time (often 12:00 AM) and a flashing radio tower/wave icon. Step 4: Signal Acquisition (The Waiting Period)
: Ensure all hands are exactly at the 12:00 position before starting. Insert Battery : Place one fresh AA alkaline battery into the compartment.
: Press and hold the SET button (or "M.SET") for 3+ seconds until the hands start moving.