Ivoclar Programat P90 Manual Jun 2026
Press the parameter key you want to modify (e.g., for peak temperature). Enter the desired numerical value using the keypad. Press Enter or the parameter key again to store the value.
Over time, thermocouple drift can cause the furnace to run too hot or too cold, ruining ceramic translucency or causing under-firing. Regular calibration is mandatory. The P90 relies on the manual :
Connect the vacuum pump hose to the vacuum connector at the back of the furnace. Secure it tightly. Plug the pump power cable into the designated outlet on the rear of the P90.
Like any precision instrument, the P90 can occasionally display error codes. The manual lists a range of errors from to Er97 , and also includes failures that are not indicated on the display. Ivoclar Programat P90 Manual
Check the pump oil, check the rubber seal ring on the muffle plate, and verify hose connections. Lift Mechanism Error The furnace head cannot reach its end position.
The P90 is a fully automatic microprocessor-controlled vacuum furnace designed for high-precision dental ceramics. Ivodent Magyarország
Energy saving feature: The furnace turns off after X minutes of inactivity. The manual shows how to disable this (important for labs running overnight burnout cycles). Press the parameter key you want to modify (e
Known for being a robust, practical, and compact, it provides efficient, accurate results.
The Programat P90 is a benchtop dental ceramic furnace designed for firing dental porcelain restorations. Its compact, timeless design houses a sophisticated control unit that manages firing cycles, vacuum, and temperature with the accuracy required for high‑quality dental work.
Regular maintenance prevents contamination of ceramic restorations and extends the life of the quartz tube. Daily Maintenance Over time, thermocouple drift can cause the furnace
The P90 manual provides guidelines for resolving common operating issues.
Never touch the hot furnace head or reach under it during operation; always use the provided tongs for placing objects in the firing chamber. Electrical Safety:
Run a blank, high-temperature cycle (up to 1050°C) with a vacuum once a week. This burns off silver, palladium, or carbon residues left behind by ceramic stains and alloy oxidation.
The baseline temperature before the cycle begins (usually 400°C to 500°C).
If you are searching for the "Ivoclar Programat P90 Manual PDF," always source it from official Ivoclar channels or trusted dental libraries to avoid outdated temperature ramps.
