Bnd-50 Se36 Instructions __full__ -

Before programming any schedules, you must set the current day and time:

Press the and "PROG" buttons simultaneously to switch between a 12-hour (AM/PM) and 24-hour time format. 6. Troubleshooting

The following instructions outline the integration of a B&B Video/Data Balun with a Sanyo SE36 unit.

Press and hold the "CLOCK" button, then press the "WEEK" button to select the current day. Note: Ensure the time format is correct (AM/PM). 3. Programming Your BND-50 SE36 bnd-50 se36 instructions

The is a programmable electronic plug-in switch designed by manufacturers like HBN and Bainian to automate household appliances. This robust device allows users to configure up to 8 to 9 distinct ON/OFF programs per day , cutting down electricity bills while securing homes through simulated occupancy.

(touchscreen)

To activate your programmed schedules, the timer must be in the correct mode. Before programming any schedules, you must set the

Before programming, ensure your connected devices match the load limitations to protect the internal circuitry. Specification BND-50/SE36 Voltage Rating 230V–240V AC, 50Hz Maximum Load Capacity 13A / 3120W (UK Variant) or 16A / 3500W (EU Variant) Minimum Interval Time Memory Profiles Up to 8 discrete ON/OFF program blocks Backup Power Integrated Ni-MH rechargeable battery Step 1: Initial Hardware Activation

Most digital BND‑50 timers use a 4‑button interface: , HOUR , MIN , WEEK .

| Terminal Block | Signal | Description | |----------------|--------|-------------| | X0 – X23 | Digital Inputs | 24V DC, 7mA typical | | Y0 – Y19 | Digital Outputs | Relay (2A) or NPN transistor | | AI0 – AI3 | Analog Input | 0-10V (impedance >100kΩ) | | AO0 – AO1 | Analog Output | 0-10V or 4-20mA | | COM | Common | For inputs/outputs | Press and hold the "CLOCK" button, then press

Always verify your exact model revision. The SE36 suffix may indicate a specific firmware version. Consult your quick-start guide for model-specific variations.

OFF." Repeat the steps above to set when you want the appliance to turn off. Press PROG again to set OFF, and repeat up to 8 times.