Insert key, turn ignition ON to manually override and silence system. Re-synchronize the transmitter using a diagnostic interface or manual sequence.
To trigger the alarm manually, press and hold Button 1 for several seconds. Removing the Motion Sensor:
The turn signals will flash once, and the LED on the dashboard will begin to flash slowly. Gemel Txshs User Manual
If your remote stops communicating with the bike—often after a battery change or if the buttons were pressed more than 256 times outside of range—you must resynchronize it.
If your remote has stopped responding—often after a battery change (CR-2032)—you may need to re-sync it with the motorcycle. Follow this procedure from Cutting Edge Automotive Solutions : Turn your key to the "On" position. Insert key, turn ignition ON to manually override
The system is outside its 30-second operational window, or code desynchronization has occurred.
The internal receiver section often interacts with a specific 30-second window after ignition shutdown. 2. Operating Instructions Removing the Motion Sensor: The turn signals will
Slide out the depleted battery (typically a or CR2016 3V lithium cell, verify variant upon opening).
Press the smooth button (Button 2) once. The indicators will flash once to signal the system is disarmed. Synchronization and Resynchronization
If the battery died slowly, the rolling code might be out of sync. Press the button repeatedly while standing next to the car. The Siren Goes Off Randomly