Dell D220p 01 Power Supply Pinout 2 !!install!! ✰ < BEST >

:

The Dell D220P-01 utilizes an 8-pin Molex-style layout. When looking directly at the front face of the male plug (the cable end coming from the power brick) with the locking clip facing upwards, the pin positions run from Pin 1 to Pin 8. Pin Number Internal Wire Color Functional Assignment Electrical Specification Remote Sense / Power-On + Control Signal Pin 2 Ground (GND) Main Negative (-) Pin 3 Ground (GND) Main Negative (-) Pin 4 Ground (GND) Main Negative (-) Pin 5 Remote Ground / Control (-) Control Signal Pin 6 +12V DC Output Main Positive (+) Pin 7 +12V DC Output Main Positive (+) Pin 8 +12V DC Output Main Positive (+) How to Turn On the Power Supply

To activate the power supply, Pin 5 (Remote/Signal) must be shorted to a Ground pin (Pins 6, 7, or 8). Mechanical Compatibility Warning: Dell D220p 01 Power Supply Pinout 2

: Tie the Blue wire directly to a Black ground wire .

To turn the power supply on manually (for DIY projects or testing), you must short Pin 5 to Ground : The Dell D220P-01 utilizes an 8-pin Molex-style layout

Viewed from the wire side (looking into the back of the connector where wires enter). Locking clip on top.

The output voltage can be adjusted from approximately 4V to 18V by altering the feedback voltage on the UCC3808 controller chip. This typically involves changing a resistor value on the control board, often R175, to set the desired voltage. It's important to note that going above 18V can significantly increase idle power consumption and may stress the output capacitors, which are typically rated at 16V. Mechanical Compatibility Warning: : Tie the Blue wire

. Plugging it directly into a standard motherboard can cause permanent damage. Safety Protections: