Commax Dp-ra01 Installation Manual Jun 2026

These shared lines handle internal intercom call chimes, cross-talk audio communication, and distributed lock triggers. Step 5: System Testing and Operation

If you are planning to install this, would you like help with:

The recommended installation height is from the finished floor level to the center of the device screen/handset. Step 2: Installing the Wall Mounting Bracket

| Specification | Details | | :--- | :--- | | | DP-RA01M (Master), DP-RA01S (Slave) | | Power Source (Master) | AC 230V, 50-60Hz | | Power Source (Slave) | Supplied by Master via wiring | | Audio Output | 70mW across 8 ohm | | Call Sound Output | High 400mW / Low 100mW (across 8 ohm) | | Wire Type | 0.65mm diameter (Approx. 22 AWG) | | Wiring Distance (Room to Room) | 30 meters (Using 0.65mm wire) | | Wiring Distance (Unifon to Gate) | 50 meters (Using 0.65mm wire) | | Dimensions (WxHxD) | 88 x 230 x 70 mm | | Weight (Master) | 450g | | Weight (Slave) | 600g | | Compliance | CE (LVD: EN60065, EMC: EN61000) | commax dp-ra01 installation manual

: Plug the DP-RA01 into a standard AC outlet (100-240V). 4. Mounting the Unit

✅ – Reversing power can fry the unit. Commax units are sensitive to reverse voltage.

Loosen the screws on and Terminal 2 at the back of the DP-RA01 handset. These shared lines handle internal intercom call chimes,

Strip approximately 5mm to 7mm of insulation off the ends of the two wires.

subgraph “Optional Second Indoor Station” D[“Commax DP-RA01S”<br>Slave Unit] end

When you look at the rear panel of the DP-RA01, you will see a terminal block with numbered slots: 22 AWG) | | Wiring Distance (Room to

Align the slots on the back of the DP-RA01 handset with the hooks on the wall bracket. Slide the unit firmly downward until it clicks securely into place. Step 6: Install the Outdoor Unit

: Connect two wires from the outdoor door station (such as the DR-201D) to the corresponding terminals on the back of the DP-RA01.

If you’ve just unboxed a video door phone monitor, you’re likely holding a device that promises security, convenience, and that satisfying "buzz" to let guests in. But before you can see who’s at the door, you have to get it on the wall.

When you have identified a visitor you wish to allow inside, you can remotely unlock the electric door strike. Just press the "Door Open" button (labeled #3 on the master unit) during your conversation or while the call is active.