: A USB drive or high-endurance SD card is recommended to host the container to avoid wearing out the internal flash memory.
She sat in her dimly lit workshop, the rhythmic blinking of a MikroTik RB5009
/routing/table/add name=to_v2ray fib /ip/route/add dst-address=0.0.0.0/0 gateway=172.16.10.2 routing-table=to_v2ray Use code with caution.
This is the cleanest approach because it keeps everything on a single device. Ensure you have enabled the container package on your MikroTik router before proceeding. Step 1: Prepare Storage and Network v2ray mikrotik
/interface bridge port add bridge=dockers interface=veth1
If traffic fails to pass through your tunnel, use this structural checklist to isolate the failure point: Likely Cause Routing loop between MikroTik and V2Ray
# Add a routing mark for proxied traffic /ip firewall mangle add chain=prerouting src-address=192.168.88.0/24 dst-address=!192.168.88.10 \ protocol=tcp action=mark-routing new-routing-mark=v2ray-mark : A USB drive or high-endurance SD card
This method details how to pull a V2Ray image, configure its parameters, and run it locally on a compatible MikroTik router. Step 1: Enable Container Support
If your MikroTik is older (MIPSBE or MMIPS), you cannot run containers. However, RouterOS includes a in /ip socks .
The container now runs a SOCKS5 proxy. To make it a full transparent gateway, we redirect traffic into it. Ensure you have enabled the container package on
Which V2Ray protocol () does your server use? Share public link
: MikroTik's FastTrack feature bypasses the firewall mangle chain to save CPU cycles. If your rules are not catching traffic, temporarily disable the default FastTrack rule in /ip firewall filter .
Deploy Linux (Ubuntu/Debian) on your mini-PC or Raspberry Pi. V2Ray Installation: Install V2Ray via the official script: bash <(curl -L https://githubusercontent.com) Use code with caution.
/queue simple add target=192.168.1.100/32 max-limit=10M/10M